Wednesday, 18 February 2015

Raasay is just about ready to launch.  I'd like to give the topsides a clean and fix a few scratches, but that's all that really needs done in the yard.  I've put on two good coats of anti-fouling, hoping that I might get two seasons out of it (with a bit of a scrub and retouch?) since I can lie afloat in Inverness.

We should be in the water by early March ...
at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Engine Swap ...

So. I found a reasonably priced 3GM30F on eBay that was in better condition than Raasay's present installation. It also has a heat excha...

  • Rudder removal
    This was, slightly unexpectedly, a stinker of a job. I thought the shoe on the bottom of the skeg would present difficulties, but the silico...
  • The Stuffing Box Hose
      This was very difficult to remove and replace. It goes from the stern tube to the stuffing box, and it's underneath the fuel tank, par...