Tuesday 18 April 2023

Moving the Outboard Mount

I wanted to move the outboard mount to the starboard side, because that's the side I normally pull the dinghy up on and because I wanted to get it out of the way of the Aries vane. It used to disturb the air over the vane when I was going upwind on a starboard tack.

The arrangement looks a bit cumbersome - I had to add an extra rail, and make quite a large panel to provide lots of places to put u-bolts.

It's a little more 'shoogly' than the stern rail position, but the lashing sorts that out. I may come up with a tidier arrangement ...


TG575663-2 TG575666-3 TG575662-1

No comments:

Post a Comment

Aries - Pin Removal in Situ

  This was a bit experimental. The vertical bearing was getting sticky again, and I was trying to think of a way of getting at it that didn&...